Testing
There are two major areas that will be tested for this project. The first is that the machine is capable of a feed rate. The second area tested will be the ability for the machine to crush the composite material. Photographs and video will be used to document the machine processing, and the material before and after status. Using a spreadsheet, the data can be collected and presented.
Modified Testing
Due to limited access to the machine, a full test has been postponed because construction is still in process. The machine will still be tested by using a rpm measuring device on the machine’s gearbox #2 output shaft. The output shaft has been modified with contrasting tape to allow for the rpm measuring device to read correctly. Using the feed rate worksheet FPM can be calculated by using the following formula: FPM = RPM * Pi* Diameter.
